7.92 K98 mauser

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Post Reply
Message
Author
Andy632

Re: 7.92 K98 mauser

#11 Post by Andy632 »

.30-06 cases easily convert to 8x57 if you have any trouble finding decent cases for reloading.
Top
User avatar
Sandgroper
Full-Bore UK Supporter
Posts: 4735
Joined: Sat Nov 06, 2010 3:45 pm
Location: Stanley, Falkland Islands
Contact:
Contact Sandgroper

Re: 7.92 K98 mauser

#12 Post by Sandgroper »

Andy632 wrote:.30-06 cases easily convert to 8x57 if you have any trouble finding decent cases for reloading.
Just curious, as I don't shoot either, do you run the 30-06 through an 8x57 FL die first and then trim?
“The standard you walk past is the standard you accept.”

Lieutenant General David Morrison

I plink, therefore I shoot.
Top
Andy632

Re: 7.92 K98 mauser

#13 Post by Andy632 »

Sandgroper wrote:
Andy632 wrote:.30-06 cases easily convert to 8x57 if you have any trouble finding decent cases for reloading.
Just curious, as I don't shoot either, do you run the 30-06 through an 8x57 FL die first and then trim?
Yup, I annealed first then run it through the 8x57 die, then trimmed.
Top
User avatar
Sandgroper
Full-Bore UK Supporter
Posts: 4735
Joined: Sat Nov 06, 2010 3:45 pm
Location: Stanley, Falkland Islands
Contact:
Contact Sandgroper

Re: 7.92 K98 mauser

#14 Post by Sandgroper »

Cheers, Andy. :good:
“The standard you walk past is the standard you accept.”

Lieutenant General David Morrison

I plink, therefore I shoot.
Top
Post Reply

Return to “Reloading and Ammunition”

Who is online

Users browsing this forum: No registered users and 1 guest