Reloader Swiss 40
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Re: Reloader Swiss 40
Do they have the full range in and do you know what they are charging per Kilo?
-
Rburro2
Re: Reloader Swiss 40
Not sure but mike is extremely helpful and I think it was 57.50 or 58.00 a kilo, give him a call he can probably get it if he doesn't stock it
Re: Reloader Swiss 40
: Pleased I could help and it is good to hear the RS powders are officially over here now.-
Rburro2
Re: Reloader Swiss 40
Hi dave can you just double check this load for not doubting you at all just always wise to double check
62grn ss109 fmj bullet
Starting 25.2grn up in increments of.2
62grn ss109 fmj bullet
Starting 25.2grn up in increments of.2
Re: Reloader Swiss 40
I have no data for ADI bullets so went for PPV instead:
Cartridge : .223 Rem. (SAAMI)
Bullet : .224, 62, PrviPartizan FMJ BT B-419
Useable Case Capaci: 25.850 grain H2O = 1.678 cm³
Cartridge O.A.L. L6: 2.270 inch = 57.66 mm
Barrel Length : 16.8 inch = 425.5 mm
Powder : RS 40
Predicted data by increasing and decreasing the given charge,
incremented in steps of 0.893% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !
Step Fill. Charge Vel. Energy Pmax Pmuz Prop.Burnt B_Time
% % Grains fps ft.lbs psi psi % ms
-08.9 84 20.40 2506 865 36889 9011 91.6 1.001
-08.0 85 20.60 2530 882 37895 9117 92.1 0.989
-07.1 86 20.80 2555 899 38926 9220 92.6 0.977
-06.3 86 21.00 2579 916 39985 9322 93.0 0.964
-05.4 87 21.20 2603 933 41073 9423 93.5 0.952
-04.5 88 21.40 2628 951 42190 9522 93.9 0.940
-03.6 89 21.60 2652 968 43338 9619 94.3 0.929
-02.7 90 21.80 2676 986 44517 9714 94.7 0.917
-01.8 91 22.00 2701 1004 45728 9807 95.1 0.906
-00.9 91 22.20 2725 1022 46973 9898 95.5 0.894 ! Near Maximum !
+00.0 92 22.40 2749 1041 48251 9987 95.8 0.883 ! Near Maximum !
+00.9 93 22.60 2773 1059 49565 10074 96.2 0.873 ! Near Maximum !
+01.8 94 22.80 2798 1078 50916 10158 96.5 0.862 ! Near Maximum !
+02.7 95 23.00 2822 1096 52304 10241 96.8 0.851 ! Near Maximum !
+03.6 96 23.20 2846 1115 53730 10321 97.1 0.841 ! Near Maximum !
+04.5 96 23.40 2870 1134 55197 10398 97.4 0.831 !DANGEROUS LOAD-DO NOT USE!
Results caused by ± 10% powder lot-to-lot burning rate variation using nominal charge
Data for burning rate increased by 10% relative to nominal value:
+Ba 92 22.40 2890 1150 57261 10069 99.5 0.819 !DANGEROUS LOAD-DO NOT USE!
Data for burning rate decreased by 10% relative to nominal value:
-Ba 92 22.40 2570 909 39489 9451 88.5 0.967
Cartridge : .223 Rem. (SAAMI)
Bullet : .224, 62, PrviPartizan FMJ BT B-419
Useable Case Capaci: 25.850 grain H2O = 1.678 cm³
Cartridge O.A.L. L6: 2.270 inch = 57.66 mm
Barrel Length : 16.8 inch = 425.5 mm
Powder : RS 40
Predicted data by increasing and decreasing the given charge,
incremented in steps of 0.893% of nominal charge.
CAUTION: Figures exceed maximum and minimum recommended loads !
Step Fill. Charge Vel. Energy Pmax Pmuz Prop.Burnt B_Time
% % Grains fps ft.lbs psi psi % ms
-08.9 84 20.40 2506 865 36889 9011 91.6 1.001
-08.0 85 20.60 2530 882 37895 9117 92.1 0.989
-07.1 86 20.80 2555 899 38926 9220 92.6 0.977
-06.3 86 21.00 2579 916 39985 9322 93.0 0.964
-05.4 87 21.20 2603 933 41073 9423 93.5 0.952
-04.5 88 21.40 2628 951 42190 9522 93.9 0.940
-03.6 89 21.60 2652 968 43338 9619 94.3 0.929
-02.7 90 21.80 2676 986 44517 9714 94.7 0.917
-01.8 91 22.00 2701 1004 45728 9807 95.1 0.906
-00.9 91 22.20 2725 1022 46973 9898 95.5 0.894 ! Near Maximum !
+00.0 92 22.40 2749 1041 48251 9987 95.8 0.883 ! Near Maximum !
+00.9 93 22.60 2773 1059 49565 10074 96.2 0.873 ! Near Maximum !
+01.8 94 22.80 2798 1078 50916 10158 96.5 0.862 ! Near Maximum !
+02.7 95 23.00 2822 1096 52304 10241 96.8 0.851 ! Near Maximum !
+03.6 96 23.20 2846 1115 53730 10321 97.1 0.841 ! Near Maximum !
+04.5 96 23.40 2870 1134 55197 10398 97.4 0.831 !DANGEROUS LOAD-DO NOT USE!
Results caused by ± 10% powder lot-to-lot burning rate variation using nominal charge
Data for burning rate increased by 10% relative to nominal value:
+Ba 92 22.40 2890 1150 57261 10069 99.5 0.819 !DANGEROUS LOAD-DO NOT USE!
Data for burning rate decreased by 10% relative to nominal value:
-Ba 92 22.40 2570 909 39489 9451 88.5 0.967
Re: Reloader Swiss 40
Not yet as I am undecided on what to go for, certainly the .308 choices are a bit slower than I would have liked and I am currently developing a Tr140 load for my 6,5x47 however I will give them a try at some point.
Who is online
Users browsing this forum: No registered users and 10 guests