Powder

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Post Reply
Message
Author
iancxx

Powder

#1 Post by iancxx »

Hiya,Been busy trying different powder,s for my .204,Tried Viht,N140,,N135,RL10,and the one that seem,s to be the best so far is Hodgen H322,so any one know a supplier with reasonable prices,
Did find that the Viht was very,very dirty through my rifle and my mates,our mod,s were full of crap,dirty cases,and quite slow compared to the H322,,my zero dropped 6" plus over a 100 yd,s,
useing the N135,compared to H322, :G
would of tested over the chrono,but it was,rain,hail,sleet all day,everything was getting soaked,Typical day off,at the mo, **** ,So all in all look,s like the H322 for now,,
Ian.
M99

Re: Powder

#2 Post by M99 »

What are you paying for H322? I currently pay £38 a tub for it.

Mike
iancxx

Re: Powder

#3 Post by iancxx »

Hiya Mike,It cost £40 for the last 1lb tub i got,The main prob is the postage,as up here it,s hard to get anything,local,might as well live in the north pole,compared to down south,,will have to have a ring around in the morn when i come in from work,
Ian
Mr_Logic

Re: Powder

#4 Post by Mr_Logic »

H322 worked for me, also RL10X, and benchmark was excellent.
iancxx

Re: Powder

#5 Post by iancxx »

Hiya mr_logic,i have a bit of rl10x to try,will have to give benchmark a run,getting the urge to reload a few now,catch you later,,ian
iancxx

Re: Powder

#6 Post by iancxx »

Hiya,all sorted with powder for now,got plenty h322,and a wee bit of bl-c2 to try,hopeing to have a busy weekend,depending on the bliddy weather,,ian
User avatar
dodgyrog
Posts: 4103
Joined: Wed Jan 05, 2011 11:17 pm
Home club or Range: Three Counties Sporting Club & Gardners Guns
Location: Consett, County Durham
Contact:

Re: Powder

#7 Post by dodgyrog »

I'm glad I could get it for you. I hope you put it to good use!
Purveyor of fine cast boolits.
All round good guy and VERY grumpy old man.
iancxx

Re: Powder

#8 Post by iancxx »

yep dodgyrog,came up with the good, as usual,better sort some bullet,s now,his coffee isnt too bad aswell,cheer,s roger,ian
Post Reply

Who is online

Users browsing this forum: Blighty and 3 guests