Rob's latest Project

[Robin128]

Adjustable comb for my White Onyx...Narrow blade in my Dewalt bandsaw methinks.

http://www.graco-corp.com/t/adjustable-comb-hardware

http://www.brownells.com/.aspx/pid=6722 ... B-HARDWARE

http://www.brownells.com/.aspx/pid=2525 ... SFER-PLATE

:-P

[ovenpaa]

Nice project, are you going to take pictures as you progress through the project? It would be a good tutorial

[Robin128]

Yes...just like the LOP Gracoil project.

But if it goes all quiet...I've buggered it!

[Robin128]

Got this useful link.

No excuse now.

[ovenpaa]

For me the important part is marking the cut so that it is square to the vertical axis of the rifle or shotgun and it takes some time to get this right, once it is marked out the butt section then needs to be packed to make sure it is square to the cut and table and if possible build a temporary fence to act as a guide for the long cut.

Lots of pictures please Rob :goodjob:

[Robin128]

Good advice ovenpaa...used a DIY jig when I did the Gracoil...link also details a simple but effective jig...order has gone off to Brownells...likely to be after Christmas when I get time to get to work on it...what with usual postal delays and HM Customs.

[dromia]

Measure with a micrometer.

Mark with chalk.

Cut with an axe.

Hammer into place.

Simples.

[Robin128]

:shakeshout: :shakeshout:

:lol: :lol: :lol:

[Scotsgun]

Nice project but doubt i'd have the balls to hack into any of mine.

[Sim G]

Nice project but doubt i'd have the balls to hack into any of mine.

Strangely enough, the same way I feel.....