Hi there.
Its been a long while since I have shot 8mm and after having the ZF-41 lenses cleaned I am now faced with rezo'ing it again.
I used load from one of my other K98's and used it in this rifle (Lyman reloading manual)
Just wanted a 2nd opinion on the fired brass if possible please. Do you think I am loading too hot ?
Thanks in advance
2nd opinion on 8x57 fired cases please
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
2nd opinion on 8x57 fired cases please
- Attachments
-
-
Re: 2nd opinion on 8x57 fired cases please
Thanks D.Ovenpaa wrote:No.
I am below max recommended, but some primers looked a little flatter / squished then what I am normally used to seeing , so just wanted to check.
Many thanks again
Who is online
Users browsing this forum: No registered users and 7 guests