Plinking load for 308 ~
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Plinking load for 308 ~
I'm interested in a light load for my 308 rifle, for 50yds and 100m plinking.
The bullet is Hornady 150gr FMJ/BT.
Powder, open to suggestion, in stock: N140, N310, Bullseye, TiteGroup, and Green Dot.
Any guidance or pointers on a lighter load than the N140 44gr I would normally use.
Thanks!
The bullet is Hornady 150gr FMJ/BT.
Powder, open to suggestion, in stock: N140, N310, Bullseye, TiteGroup, and Green Dot.
Any guidance or pointers on a lighter load than the N140 44gr I would normally use.
Thanks!
Re: Plinking load for 308 ~
You do not say at what distance you are plinking. I shoot with 41 grains of N140 for plinking to a couple of hundred yards.
- dodgyrog
- Posts: 4103
- Joined: Wed Jan 05, 2011 11:17 pm
- Home club or Range: Three Counties Sporting Club & Gardners Guns
- Location: Consett, County Durham
- Contact:
Re: Plinking load for 308 ~
I'd go a different route and use light weight cast boolits with light loads of pistol powder.
Lyman's Cast Bullet Manual would be useful as a starting point.
Lyman's Cast Bullet Manual would be useful as a starting point.
Purveyor of fine cast boolits.
All round good guy and VERY grumpy old man.
All round good guy and VERY grumpy old man.
Re: Plinking load for 308 ~
50yds, or 100m... no further, sadly (for plinking).Ovenpaa wrote:You do not say at what distance you are plinking...
Re: Plinking load for 308 ~
That's what I was wondering about... (pistol powder).dodgyrog wrote:I'd go a different route and use light weight cast boolits with light loads of pistol powder.
Lyman's Cast Bullet Manual would be useful as a starting point.
Where would be a good place to obtain such boolits..?
- WelshShooter
- Full-Bore UK Supporter
- Posts: 1812
- Joined: Wed Jun 25, 2014 9:45 pm
- Contact:
Re: Plinking load for 308 ~
Shell house bullet company make a 110gr RN cast bullet sized to .309". I use this bullet in my M1 carbine, not sure if this will be too light for 308 or not?
You may want to read up on "The Load" which is located in the library of this forum as there is a lot of info regarding the use of pistol powder with military calibres such as 30'06, 8mm Mauser etc. If I recall, the load was based on red dot powder.
You may want to read up on "The Load" which is located in the library of this forum as there is a lot of info regarding the use of pistol powder with military calibres such as 30'06, 8mm Mauser etc. If I recall, the load was based on red dot powder.
- dromia
- Site Admin
- Posts: 20230
- Joined: Sat Nov 06, 2010 4:57 am
- Home club or Range: The Highlands of Scotland. Cycling Proficiency 1964. Felton & District rifle club. Teesdale Pistol and Rifle club.
- Location: Sutherland and Co Durham
- Contact:
Re: Plinking load for 308 ~
Four grains of any fast pistol powder, N310, N320, Bullseye, Red Dot under a well fitting for you rifle soft lead bullet in the 90-130 gn range, heavier that is longer bullet for 100yrds plus.
A search of these forums will reveal much on this subject as it has been done to death on here at various times in the past.
A search of these forums will reveal much on this subject as it has been done to death on here at various times in the past.
Come on Bambi get some
Imperial Good Metric Bad
Analogue Good Digital Bad
Fecking stones
Real farmers don't need subsidies
Cow's farts matter!
For fine firearms and requisites visit
http://www.pukkabundhooks.com/
Re: Plinking load for 308 ~
For 50 metres and 100 yards I shoot the lee 150 gr flat nose with vectan gm3 for 1800 fps and consistent sub moa accuracy. Per round this costs less than a jacketed bullet and doesn't wear the barrel. I shoot around 2000 rounds per year with cast with jacketed bullets reserved for 200 yards +.
"Consciousness is a lie your brain tells you to make you think you know what you are doing." Professor Maria Goncalves.
If liberty means anything at all, it means the right to tell people what they do not want to hear. George Orwell.
If liberty means anything at all, it means the right to tell people what they do not want to hear. George Orwell.
Who is online
Users browsing this forum: No registered users and 2 guests