Hi all I'm after some advice please.
Have just pulled about 50 cartridges to reload, the pulled bullets were lead with gas checks.
In half a dozen the lead bullet has come out but the gas check is still in the cartridge, How is best to remove the gas check or at least make the safe.
The powder is trail boss if that helps.
Thanks @nd
Bullet pulling
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Re: Bullet pulling
I get as much powder out first, pushing the check all the way in if necessary. Then, with the case upside down, vigorously shake until I have the check sideways on in the neck, then reach in and pull out with thin nose pliers.
"Consciousness is a lie your brain tells you to make you think you know what you are doing." Professor Maria Goncalves.
If liberty means anything at all, it means the right to tell people what they do not want to hear. George Orwell.
If liberty means anything at all, it means the right to tell people what they do not want to hear. George Orwell.
- dromia
- Site Admin
- Posts: 20230
- Joined: Sat Nov 06, 2010 4:57 am
- Home club or Range: The Highlands of Scotland. Cycling Proficiency 1964. Felton & District rifle club. Teesdale Pistol and Rifle club.
- Location: Sutherland and Co Durham
- Contact:
Re: Bullet pulling
I just re-expand the neck a tad with an "M" die and it just drops out.
Come on Bambi get some
Imperial Good Metric Bad
Analogue Good Digital Bad
Fecking stones
Real farmers don't need subsidies
Cow's farts matter!
For fine firearms and requisites visit
http://www.pukkabundhooks.com/
Re: Bullet pulling
Thanks for the help chaps. gas checks out with pliers but i will invest in a ''M'' die as it will happen again.
Regards Andrew
Regards Andrew
- dromia
- Site Admin
- Posts: 20230
- Joined: Sat Nov 06, 2010 4:57 am
- Home club or Range: The Highlands of Scotland. Cycling Proficiency 1964. Felton & District rifle club. Teesdale Pistol and Rifle club.
- Location: Sutherland and Co Durham
- Contact:
Re: Bullet pulling
You really cannot load cast bullets properly without an appropriately sized "M" die style expander, never mind removing stuck gas checks.
Come on Bambi get some
Imperial Good Metric Bad
Analogue Good Digital Bad
Fecking stones
Real farmers don't need subsidies
Cow's farts matter!
For fine firearms and requisites visit
http://www.pukkabundhooks.com/
Re: Bullet pulling
Thanks for the advice Dromia.
I dont reload using lead bullets, they were given to me (with more to come), so i was pulling them to re use the cases.
Andrew
I dont reload using lead bullets, they were given to me (with more to come), so i was pulling them to re use the cases.
Andrew
Who is online
Users browsing this forum: No registered users and 3 guests