Lee ergo handle upgrade kit
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
bradaz11
- Full-Bore UK Supporter
- Posts: 4789
- Joined: Mon Jun 02, 2014 1:23 am
- Home club or Range: The tunnel at Charmouth, BWSS
- Location: Bristol
- Contact:
Lee ergo handle upgrade kit
Can anyone tell me why handle won't fit a lee classic cast? It just says it will only fit a 1k and cheapo turret
When guns are outlawed, only Outlaws will have guns
Re: Lee ergo handle upgrade kit
The Ergo handle is made out of 1/2" stock, whereas the standard Classic Cast handle is made from 5/8".
It will actually fit quite happily in the Classic press, you just have to torque down on the fastening. However the handle does rotate a bit in use - probably a wrap of duct tape might help.
Triffid
It will actually fit quite happily in the Classic press, you just have to torque down on the fastening. However the handle does rotate a bit in use - probably a wrap of duct tape might help.
Triffid
-
bradaz11
- Full-Bore UK Supporter
- Posts: 4789
- Joined: Mon Jun 02, 2014 1:23 am
- Home club or Range: The tunnel at Charmouth, BWSS
- Location: Bristol
- Contact:
Re: Lee ergo handle upgrade kit
Ah that makes sense, sure I have some stock that can make up 1/8
When guns are outlawed, only Outlaws will have guns
-
bradaz11
- Full-Bore UK Supporter
- Posts: 4789
- Joined: Mon Jun 02, 2014 1:23 am
- Home club or Range: The tunnel at Charmouth, BWSS
- Location: Bristol
- Contact:
Re: Lee ergo handle upgrade kit
Bought one, figured I'd just try it first as on removing the handle, the sleeve goes a good way in. Bolt could do with being a tiny bit shorter but feels ok as is
So for anyone else wondering if it will fit a classic cast turret, yes it will
![Image](https://uploads."An application"-cdn.com/20191012/caf03cf1233d89446b5d67d8353f97d0.jpg)
So for anyone else wondering if it will fit a classic cast turret, yes it will
When guns are outlawed, only Outlaws will have guns
Who is online
Users browsing this forum: No registered users and 5 guests