6.5 Creedmoor neck size dies

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Post Reply
Message
Author
Gerry939

6.5 Creedmoor neck size dies

#1 Post by Gerry939 »

Can't find a neck sizing die for my 6.5 Creedmoor ,any suggestions...would any other 6.5 do the job....t thankssign :flag6:
The Gun Pimp
Posts: 1154
Joined: Fri Dec 10, 2010 3:08 pm
Contact:

Re: 6.5 Creedmoor neck size dies

#2 Post by The Gun Pimp »

Suggestions? Yeh - full-length size. Why wouldn't yer?
User avatar
phaedra1106
Posts: 3429
Joined: Wed Feb 08, 2012 9:37 pm
Location: Just outside Sacriston (the nice bit!)
Contact:

Re: 6.5 Creedmoor neck size dies

#3 Post by phaedra1106 »

As above, no real benefit, set you die to give minimal head space for your chamber and just full length size :)
There's room for all Gods creatures, next to the mash and gravy :)
Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests