An accurate tracing of the outline would be ideal along with the overall dimensions.
The reason being is that I want to put one onto a Lee bench mounting plate so it can be used in my existing setup,
RCBS Rock Chucker Supreme Base info?
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
phaedra1106
- Posts: 3429
- Joined: Wed Feb 08, 2012 9:37 pm
- Location: Just outside Sacriston (the nice bit!)
- Contact:
RCBS Rock Chucker Supreme Base info?
Can anyone who has one of these possibly post up a drawing of the base please, similar to this one but better accuracy,
An accurate tracing of the outline would be ideal along with the overall dimensions.
The reason being is that I want to put one onto a Lee bench mounting plate so it can be used in my existing setup,
An accurate tracing of the outline would be ideal along with the overall dimensions.
The reason being is that I want to put one onto a Lee bench mounting plate so it can be used in my existing setup,
There's room for all Gods creatures, next to the mash and gravy :)
Who is online
Users browsing this forum: Google [Bot] and 3 guests