The UK's Finest Independent Forum for Shooters and Gun Owners. Est 2010.

They've started to appear in the U.S. Does anyone make one over here ?

ASE in Finland do them in .270

Lawrence precision definitely will.

However, 6.5 cal is nothing new so would imagine pretty much every moderator manufacturer would do them?

macc tech , uk designed and manufactured , calibre specific.

One Less Charlie

http://www.onelesscharlie.co.uk/products.html

Alan

saddler wrote:ASE in Finland do them in .270

Their compatibility chart shows the .25 cal moderators to be optimum for 6.5/.260.

http://www.aseutra.fi/s-series-sl5-suppressor

DL. wrote:

saddler wrote:ASE in Finland do them in .270

Their compatibility chart shows the .25 cal moderators to be optimum for 6.5/.260.

http://www.aseutra.fi/s-series-sl5-suppressor

Aye - stand corrected!

I knew that they did one close to .270, as I'd been after one for my 6.8
In the end I opted for the .30-cal size: as it's less of a mess to use, not swaging the jackets off passing 6.8 bullets like the .25 moderator would be likely to do...

saddler wrote: In the end I opted for the .30-cal size: as it's less of a mess to use, not swaging the jackets off passing 6.8 bullets like the .25 moderator would be likely to do...

I've got one of their .25 cal S5's - it's good, very heavily built. I even ran it on a larger calibre for a little while, but bottled it when I sat down and thought about the rather slim internal clearance the bullet had!

It all depends on the tolerances of the muzzle thread, but shootings a pastime where you don't get many second chances!

ASE appear to have a good reputation right ?

TJC wrote:ASE appear to have a good reputation right ?

VERY much - as with most Finnish makers (Sako, Tikka, Lapua, etc.) = top quality kit