Does anyone in Europe make a 6.5mm moderator ?

[TJC]

They've started to appear in the U.S. Does anyone make one over here ?

[saddler]

ASE in Finland do them in .270

[zanes]

Lawrence precision definitely will.

However, 6.5 cal is nothing new so would imagine pretty much every moderator manufacturer would do them?

[tackb]

macc tech , uk designed and manufactured , calibre specific.

[20series]

One Less Charlie

http://www.onelesscharlie.co.uk/products.html

Alan

[DL.]

ASE in Finland do them in .270

Their compatibility chart shows the .25 cal moderators to be optimum for 6.5/.260.

http://www.aseutra.fi/s-series-sl5-suppressor

[saddler]

ASE in Finland do them in .270

Their compatibility chart shows the .25 cal moderators to be optimum for 6.5/.260.

http://www.aseutra.fi/s-series-sl5-suppressor

Aye - stand corrected!

I knew that they did one close to .270, as I'd been after one for my 6.8
In the end I opted for the .30-cal size: as it's less of a mess to use, not swaging the jackets off passing 6.8 bullets like the .25 moderator would be likely to do...

[DL.]

In the end I opted for the .30-cal size: as it's less of a mess to use, not swaging the jackets off passing 6.8 bullets like the .25 moderator would be likely to do...

I've got one of their .25 cal S5's - it's good, very heavily built. I even ran it on a larger calibre for a little while, but bottled it when I sat down and thought about the rather slim internal clearance the bullet had!

It all depends on the tolerances of the muzzle thread, but shootings a pastime where you don't get many second chances!

[TJC]

ASE appear to have a good reputation right ?

[saddler]

ASE appear to have a good reputation right ?

VERY much - as with most Finnish makers (Sako, Tikka, Lapua, etc.) = top quality kit