Page 1 of 1
Lee Collet Neck Die.
Posted: Fri Mar 28, 2014 11:15 am
by fred2892
Has anyone tried using 7.62x54r brass in the .303B Lee collet neck die?
Will it fit or is some machining required?
Sent from my Transformer TF101 using "An application"
Re: Lee Collet Neck Die.
Posted: Fri Mar 28, 2014 1:06 pm
by DanTheMan
I use a Lee 308 neck die on 7.62x54 brass, put the case through a 3mm washer first to engage the collet.
Re: Lee Collet Neck Die.
Posted: Fri Mar 28, 2014 2:08 pm
by fred2892
Thanks Dan, can you tell me the internal neck dimension of the 7.62x 54 brass after using the 308 die?
Sent from my Transformer TF101 using "An application"
Re: Lee Collet Neck Die.
Posted: Fri Mar 28, 2014 3:43 pm
by dromia
I usually cut the washer to the same opening as the shell holder then JB weld it in place. Then it is just a shell holder and as easy to use.