This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Steve wrote:Right,i de-primed my goofed cases this morning and they're now resized correctly.Must admit that when i popped the first primer out i was wincing,but it didnt go bang.Was doing it through a yellow hue though because i wore my safety shooting glasses!
The first time I used a bullet pulling hammer, I was cacking it, as it seemed wrong - I put an old piece of worktop between me and the block I was hitting, and lent round it :lol:
Dougan wrote:
The first time I used a bullet pulling hammer, I was cacking it, as it seemed wrong - I put an old piece of worktop between me and the block I was hitting, and lent round it :lol:
Have a good shoot tomorrow :)
Didnt have to pull any this time Dougan,but i do hate pulling bullets.Like you say it just seems so wrong hitting the hammer as hard as you can with a live round inside it and it makes me clench my buttocks every time.
and Robin-its not character building.More like sanity destroying. :lol:
I must admit to being a tad twitchy the first time I pulled a bullet apart using a kinetic hammer, it seems very wrong to whack something with a bullet inside onto a piece of concrete. These days I uses a press mounted collet puller.
I do remember building some .303's a while ago and standing them on a flat surface only to notice they wobbled. Ooops! The primers had not been fully seated, so back in the primer tool they went for that final little push to seat the primers. Twitchy? Nah!
/d
Du lytter aldrig til de ord jeg siger. Du ser mig kun for det tøj jeg har paa ...
Yes and stuck them in sideways whilst using a case holder without a slot in it so I could not get the case out to pull the primer out, I had to bash it out with a flash hole uniformer (Whilst cringing at the same time)
/d
Du lytter aldrig til de ord jeg siger. Du ser mig kun for det tøj jeg har paa ...
:lol: 
