Re: NEED SOME ADVICE ON 308 DIE
Posted: Mon May 30, 2011 1:46 pm
If they are head stamped Lapua 308 Win then they are boxer primed. Does the primer get pushed out right at the end of the stroke? I do wonder if the decapping pin is adjusted long which has caused it to bend slightly and cause the pins to break, personally I think that is a long shot but worth checking. Redding dies are of a good quality so you should not be experiencing problems like this.
What sort of press do you use and is the ram a good fit through the frame or can you move it much side to side when it is fully up and without a die in?
What sort of press do you use and is the ram a good fit through the frame or can you move it much side to side when it is fully up and without a die in?