I use one of 3m self adhesive hooks and I opened out the ring from a large key ring for my westlake browning buckmark LBP.
Works well for me.
The photo has attached on its side but it is hanging upright in the cabinet.
Cheers
Shoppe
LBR & LBP Storage
Moderator: dromia
- Dark Skies
- Posts: 2847
- Joined: Tue Apr 22, 2014 11:02 am
- Home club or Range: NRA
- Contact:
Re: LBR & LBP Storage
I bought a bunch of those strong Neodymium magnetic hooks and placed them on the inside of the cabinet - hang them by the trigger guards. I slip a piece of plastic hose over the hook to prevent scratches to the guard and some closed cell rubber foam pads placed strategically so the frame / barrel don't contact the cabinet.
"I don't like my job and I don't think I'm gonna go anymore."
- Pippin89
- Posts: 1032
- Joined: Thu Apr 04, 2019 11:54 am
- Home club or Range: Chichester Rifle and Pistol Club
- Location: West Sussex, UK
- Contact:
Re: LBR & LBP Storage
Thanks all for your ideas.
- bradaz11
- Full-Bore UK Supporter
- Posts: 4771
- Joined: Mon Jun 02, 2014 1:23 am
- Home club or Range: The tunnel at Charmouth, BWSS
- Location: Bristol
- Contact:
Re: LBR & LBP Storage
for bp revolvers i have a shoe organiser on the back wall, they type for a door. cut it in half then fixed it in. one gun per pocket. or suppressors etc.
When guns are outlawed, only Outlaws will have guns
- Mike357
- Posts: 3634
- Joined: Sat Dec 04, 2010 7:25 pm
- Home club or Range: NRA, Bisley, Dundee Rifle & Pistol Club & Bishop Auckland GC
- Location: Near Durham(ish)!
- Contact:
Re: LBR & LBP Storage
I tried magnets on the back of the cabinet door but on a vertical surface the GSG was too heavy for 1 and 2 so I had to try 3 which was a PITA. Eventually hung it by th ehammer from one magnet hook on the bottom of the ammo section of the cabinet.
I didn't fancy resting it on the muzzle or the back of the rod.
I didn't fancy resting it on the muzzle or the back of the rod.
It's not the pace of life that concerns me, it's the sudden stop at the end!
-
- Posts: 94
- Joined: Wed May 23, 2018 12:58 pm
- Home club or Range: NRA Bisley
- Contact:
Re: LBR & LBP Storage
I bought a couple of neodymium magnet coat hooks from Amazon. One goes in the trigger guard and the other is against the rod to stop the whole thing rotating about the TG. Works really well and easily supports my GSG - @Mike357 they are called 'Mavoro Magnetic Hooks' and are rated to 14lbs each horizontal weight. Hope that helps!
Dave
Dave
Who is online
Users browsing this forum: No registered users and 1 guest