Where to test loads?
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Where to test loads?
Hi All
Hopefully a quick and easy one! I shoot 223 in F/TR, or at least I am slaving away to get it working right :-)
I have recently moved to the Midlands (Daventry), and I need somewhere to test loads, and most importantly chrono them. I know I can use Bisley @ 100y to test, but AFAIK I can't use a chrono there (not seen one being used so am assuming, called the range office but got very-unhelpful voicemail).
When I lived in Reading I just used to use one of the vermin shooting permissions I had with a suitable backstop and setup the chrono there, but I haven't got anywhere to shoot in the field in the Midlands as yet.
Where do you all chrono and test loads? Need to get some real data in!
I've had some success with the 80.5 Bergers and the 90 Berger VLDs, and now need to get some velocity data to know where to go from here - guesstimates are not the best thing to go on!
Many thanks for all your help!!
Hopefully a quick and easy one! I shoot 223 in F/TR, or at least I am slaving away to get it working right :-)
I have recently moved to the Midlands (Daventry), and I need somewhere to test loads, and most importantly chrono them. I know I can use Bisley @ 100y to test, but AFAIK I can't use a chrono there (not seen one being used so am assuming, called the range office but got very-unhelpful voicemail).
When I lived in Reading I just used to use one of the vermin shooting permissions I had with a suitable backstop and setup the chrono there, but I haven't got anywhere to shoot in the field in the Midlands as yet.
Where do you all chrono and test loads? Need to get some real data in!
I've had some success with the 80.5 Bergers and the 90 Berger VLDs, and now need to get some velocity data to know where to go from here - guesstimates are not the best thing to go on!
Many thanks for all your help!!
Re: Where to test loads?
Mr_Logic
Welcome to the forum!
What about Minsterley or Severn Tunnel near the toll booths, M4 S E Wales?
http://www.minsterleyranges.com/
Welcome to the forum!
What about Minsterley or Severn Tunnel near the toll booths, M4 S E Wales?
http://www.minsterleyranges.com/
Re: Where to test loads?
You can Chrono on Short Siberia at Bisley without problems, just get set up early. Watch out as you may well become everyone' new best friend if you have a Chrono set up! Another very good alternative is Kynamco at Mildenhall who have a 100m tunnel range so no wind to worry about, they have a chrono as well but you are probably better off taking your own. From memory the range fee is GBP30/Hr
http://www.kynochammunition.co.uk/
You are gauranteed perfect test conditions at Kynamco and it is an easyish drive from you as well.
Welcome to the forum.
http://www.kynochammunition.co.uk/
You are gauranteed perfect test conditions at Kynamco and it is an easyish drive from you as well.
Welcome to the forum.
Re: Where to test loads?
Thanks guys, that's really helpful! Ovenpaa, presumably you mean just get setup before the hooter goes, and then retrieve gear after it goes for the finish at the end of the session?
I'm having a look at the link you posted now as well - looks incredibly useful, though cost may make me wince!
I'm having a look at the link you posted now as well - looks incredibly useful, though cost may make me wince!
Re: Where to test loads?
The tunnel range is pricey and I personally dislike the lighting, or more to the point my eyes struggle with it for some reason, I think if you are well prepared you can get a lot done in 60 minutes and you are not going to be distracted by other shooters.
For Bisley yes just set up the chrono before the hooter goes. I have found that you can usually move forward the ten feet to adjust it if needed as long as you choose a lull in the shooting and speak to the other shooters.
We shoot just south of Cambridge at 800-1200 yards and again you usually set a Chrono up if needed.
For Bisley yes just set up the chrono before the hooter goes. I have found that you can usually move forward the ten feet to adjust it if needed as long as you choose a lull in the shooting and speak to the other shooters.
We shoot just south of Cambridge at 800-1200 yards and again you usually set a Chrono up if needed.
- 20series
- Full-Bore UK Supporter
- Posts: 4941
- Joined: Mon Nov 08, 2010 10:42 am
- Home club or Range: Oundle R&PC
- Location: Chelveston, Northants
- Contact:
Re: Where to test loads?
Hi
Have a look here,my club is not a million miles from you.
http://orpc.org.uk/about
Oundle have 25, 50 and 100 yard ranges, we can use chronos there depending on how busy it is due to a club rule of having adjacent lanes not in use whilst a chrono is on the range, but this is normally easily done.
Any questions PM me
Cheers
Alan
Have a look here,my club is not a million miles from you.
http://orpc.org.uk/about
Oundle have 25, 50 and 100 yard ranges, we can use chronos there depending on how busy it is due to a club rule of having adjacent lanes not in use whilst a chrono is on the range, but this is normally easily done.
Any questions PM me
Cheers
Alan
A common mistake that people make when trying to design something completely foolproof is to underestimate the ingenuity of complete fools!!
Douglas Adams, 1952-2001 RIP
Douglas Adams, 1952-2001 RIP
Re: Where to test loads?
Let someone else use your chrono and wonder who pays for it when some clot doesn't miss it!
Re: Where to test loads?
Try Minsterly Ranges used to be a member there,very good for load development you can reload just behind firing points.If you go on a weekend there will be plenty of target shooters there to help you out.You might have a word with owner he still holds the record for benchrest at 100m,hope this helps



Who is online
Users browsing this forum: No registered users and 5 guests