It’s Glock o’clock

[Gh0st]

Could save you the hassle?

[safetyfirst]

TA-DAAAAAAAAAA!

I’m off down the range with it next week, I’ll let you know how it goes!

[Gh0st]

Love the colour, same as my new shotgun....

[AL8]

very nice, I bet you cant wait

[JammyGuns]

Very cool indeed. What's the weight like?

[J4mes]

Yep I like that, what's the price like?

[safetyfirst]

Base pistol with two ten rounders and a fifteen is £850 or a bit less.

That lot was £1035.

Weight is nice, balance is good I think, I’m just printing the suppressor insert. He sells them but I’m making my own.

Yes, the barrel stops just inside that can, the can is welded on and the end cap comes off.....

I’m going to play around with baffle designs, given the freedom of 3D printing, all sorts of twists and turns are possible when you don’t have to bend to the will of the lathe.

[bradaz11]

so how do you clean the barrel? just leave the slide hanging over the barrel, or have they done something to slide so it can pass through?

[Gh0st]

Is it for plinking only?

[safetyfirst]

It’s strips like a regular Glock (the lower is Gen 3 compatible) and you can tilt the barrel to clean the breech face etc, it’s easy enough to clean but you cannot remove the barrel from the slide.

The barrel isn’t secured by anything to the frame, just like a regular pistol.

I’d be quite surprised if it turned out anywhere near as accurate as a k22 but not that surprised if it was as good as the GSG 1911.

It’s for steels and perhaps three gun type stuff, mostly it’s because Glock though, I’ve always loved them in the hand and the chance to own a legal one was far too tempting to pass up.

Range report next week with luck, depends somewhat on the snow....