If like me you reload in an outside workshop or shed don't forget to give the bare surfaces of your press and tools a light wipe of oil to prevent corrosion or bring them inside where they are warm and dry. There is nothing worse than finding your favourite whatever has a coat of rust on it when you go to use it next. This also applies to rifles if they are stored in a cabinet bolted to a cold outside wall in an unheated part of your house.
WD40 evaporates over a period of time and is best avoided.
Winter maintenance
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Who is online
Users browsing this forum: drone and 0 guests