Forum rules
All groups are welcome to post unless your user name is in Newly Registered Red, your post will be removed.
No disparaging remarks, if you don't like what you see then don't buy it.
Anyone know where I could find a coach gun suitable for an FAC slot (will be used for CAS)?
The only one I have seen is this Pedersoli which is a bit pricy at £1355
There seems to be a few makers of coach guns, but all the info I have found is based out of the US.
As a Section 1 shotgun they can be cut to 24" (12"+12") however they look awful like this in my opinion however leaning on the short side of LOP and an 16-18" ish barrel is a great compromise and looks the part as well.
/d
Du lytter aldrig til de ord jeg siger. Du ser mig kun for det tøj jeg har paa ...
Ovenpaa wrote:As a Section 1 shotgun they can be cut to 24" (12"+12") however they look awful like this in my opinion however leaning on the short side of LOP and an 16-18" ish barrel is a great compromise and looks the part as well.
What about the bit of the act that says you can only shorten a shotgun to repair a damaged part ?
Ovenpaa wrote:As a Section 1 shotgun they can be cut to 24" (12"+12") however they look awful like this in my opinion however leaning on the short side of LOP and an 16-18" ish barrel is a great compromise and looks the part as well.
What about the bit of the act that says you can only shorten a shotgun to repair a damaged part ?
I wanted to convert a sec 2 greener to sec 1 but was told it cannot be done due to.....
Subject to this section, it is an offence to shorten the barrel of a shot gun to a length less than 24 inches.
(2)It is not an offence under subsection (1) above for a registered firearms dealer to shorten the barrel of a shot gun for the sole purpose of replacing a defective part of the barrel so as to produce a barrel not less than 24 inches in length