Hi
I have a bullet feeder kit which I find works pretty well for my M1 carbine, as long as a bit of care is taken. I'd like to purchase a feed die kit to do .38spl/.375mag. Lee list either a 9mm/.365" or a .40" set. My initial thought was to go for the 9mm and use a Dremel to open it up slightly if it was too tight.
Has anyone any experience of which would be the better choice?
Cheers
Donald
Bullet feeder for Lee progressive press
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
bradaz11
- Full-Bore UK Supporter
- Posts: 4789
- Joined: Mon Jun 02, 2014 1:23 am
- Home club or Range: The tunnel at Charmouth, BWSS
- Location: Bristol
- Contact:
Re: Bullet feeder for Lee progressive press
38 spl is 0.357 ish, 9mm is 0.355 ish. the 9mm kit will be fine
When guns are outlawed, only Outlaws will have guns
-
MrD
- Full-Bore UK Supporter
- Posts: 274
- Joined: Wed Jan 18, 2012 10:47 pm
- Location: Forres, Moray
- Contact:
Re: Bullet feeder for Lee progressive press
Just thought I'd check
Who is online
Users browsing this forum: Bing [Bot] and 5 guests