.Re: hornady neck sizing 6.5 die
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
Gerry939
Re: hornady neck sizing 6.5 die
Im neck sizing using Hornady 6.5 neck sizing die, has anyone else used one, following instructions i removed the expander/decapper and slowly lowered the die to meet case then in incruments to try to neck size the whole neck,but as it went down he top of the neck got tighter, i put the expander back and now cases are a bit wide and how far down the neck does one need to go .
.Who is online
Users browsing this forum: No registered users and 5 guests