Hi Alan just found this parts reference for RCBS products. The exploded view for the Trim Pro shows 6 separate compression springs, see http://www.helmuthofmann.de/pdf/parts_book.pdf
You need to scroll through 'Presses' to find the Trim Pro - gives part numbers and qty for all RCBS products. A useful resource.
regards Colin
RCBS Trim pro spring loaded case holder
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
20series
- Full-Bore UK Supporter
- Posts: 4941
- Joined: Mon Nov 08, 2010 10:42 am
- Home club or Range: Oundle R&PC
- Location: Chelveston, Northants
- Contact:
Re: RCBS Trim pro spring loaded case holder
Colin
Many thanks I'll look at this and get the bits ordered
Alan
Many thanks I'll look at this and get the bits ordered
Alan
A common mistake that people make when trying to design something completely foolproof is to underestimate the ingenuity of complete fools!!
Douglas Adams, 1952-2001 RIP
Douglas Adams, 1952-2001 RIP
Who is online
Users browsing this forum: No registered users and 18 guests