Bullets Tumbling...

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Message
Author
User avatar
dromia
Site Admin
Posts: 20229
Joined: Sat Nov 06, 2010 4:57 am
Home club or Range: The Highlands of Scotland. Cycling Proficiency 1964. Felton & District rifle club. Teesdale Pistol and Rifle club.
Location: Sutherland and Co Durham
Contact:

Re: Bullets Tumbling...

#11 Post by dromia »

For success with cast bullets you really need to cast your own, there are no volume commercial bullets available in this country that are of any use unless you happen to have a gun that fits the commercial bullets which are invariably too small and too hard with poor quality ineffective lube.
Image

Come on Bambi get some

Imperial Good Metric Bad
Analogue Good Digital Bad

Fecking stones

Real farmers don't need subsidies

Cow's farts matter!

For fine firearms and requisites visit

http://www.pukkabundhooks.com/
SkyDyno

Re: Bullets Tumbling...

#12 Post by SkyDyno »

Thanks for the help and advice....

Now see if I can get hold of a batch of .431 bullets and see what the results are.
User avatar
Mattnall
Full-Bore UK Supporter
Posts: 2940
Joined: Wed Mar 06, 2013 5:32 pm
Home club or Range: NRA, Redricks TSC, BS1944RC, HRA
Location: East Herts
Contact:

Re: Bullets Tumbling...

#13 Post by Mattnall »

SkyDyno wrote:My apologies to all.....

Bullet is what I meant.

Consider your point made. :oops:
Don't beat yourself up over it. If the likes of Henry Kranks, Sportsman GC and several other gun shops/suppliers can get away with calling them heads I think you can be forgiven.
Arming the Country, one gun at a time.

Good deals with Paul101, Charlotte the flyer, majordisorder, Charlie Muggins, among others. Thanks everybody.
User avatar
bradaz11
Full-Bore UK Supporter
Posts: 4789
Joined: Mon Jun 02, 2014 1:23 am
Home club or Range: The tunnel at Charmouth, BWSS
Location: Bristol
Contact:

Re: Bullets Tumbling...

#14 Post by bradaz11 »

these?
Attachments
16507995_10154012010266735_5985463404717688490_n.jpg
When guns are outlawed, only Outlaws will have guns
SkyDyno

Re: Bullets Tumbling...

#15 Post by SkyDyno »

bradaz11 wrote:these?
Absolutely....... love it.....
SkyDyno

Re: Bullets Tumbling...

#16 Post by SkyDyno »

dodgyrog - I've no PM etc.....
monkeyhanger
Posts: 34
Joined: Sun Nov 02, 2014 5:11 pm
Contact:

Re: Bullets Tumbling...

#17 Post by monkeyhanger »

check the box of bullets are not for the 44-40 calibre. I was once given these by mistake and I could tell that they were a smaller diameter than .44 magnum bullets
FredB
Posts: 969
Joined: Fri Dec 10, 2010 8:33 pm
Home club or Range: stourport
Location: Wolverhampton
Contact:

Re: Bullets Tumbling...

#18 Post by FredB »

??? 44-40 and 44 mag take the same diameter of bullet.
Fred
User avatar
dodgyrog
Posts: 4103
Joined: Wed Jan 05, 2011 11:17 pm
Home club or Range: Three Counties Sporting Club & Gardners Guns
Location: Consett, County Durham
Contact:

Re: Bullets Tumbling...

#19 Post by dodgyrog »

FredB wrote:??? 44-40 and 44 mag take the same diameter of bullet.
Fred
44/40 = .427" dia
44 spl and mag = .429" dia
Purveyor of fine cast boolits.
All round good guy and VERY grumpy old man.
User avatar
dromia
Site Admin
Posts: 20229
Joined: Sat Nov 06, 2010 4:57 am
Home club or Range: The Highlands of Scotland. Cycling Proficiency 1964. Felton & District rifle club. Teesdale Pistol and Rifle club.
Location: Sutherland and Co Durham
Contact:

Re: Bullets Tumbling...

#20 Post by dromia »

All my 44-40 and 44 Spec/Mag guns have all used 0.430" soft lead bullets for all velocities pertinent to the calibre with excellent effect.
Image

Come on Bambi get some

Imperial Good Metric Bad
Analogue Good Digital Bad

Fecking stones

Real farmers don't need subsidies

Cow's farts matter!

For fine firearms and requisites visit

http://www.pukkabundhooks.com/
Post Reply

Who is online

Users browsing this forum: No registered users and 6 guests