I don't use lead, far too much hassle...
Still got close to 200 Sierra's left so should be ok for a while. In addition, I've just bought 200 174grn PPU heads from ITL for £19.50 per hundred, to me it's just not worth moulding my own.
I'm a keen metal detectorist so supplies of lead are dug up every time I go out, I pass it on to one of my mates who reloads musket balls for two of his guns.
lee loaders
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
bhodge
Re: lee loaders
http://www.cdsgltd.co.uk/lee-rgbdieset.html
These are the dies i use.
As I said previously, I use these for everything apart from decapping and resizing. I use the Lee Loader for those actions.
These are the dies i use.
As I said previously, I use these for everything apart from decapping and resizing. I use the Lee Loader for those actions.
Re: lee loaders
Just hone out the die a couple of thou with a dowel and fine wet and dry Chris. Works for me.ballkeeper wrote:But May not be good for the size bullet I needswotty wrote:I've got two one for .303 and one for .308 greatt ools for the money and save loads on ammo.
Would I have been better off with collect dies instead
Joe
guys for your help,Re: lee loaders
This is good stuff if you don't fancy using ammonia....
http://shootingshed.co.uk/oscom/product ... cts_id=111
http://shootingshed.co.uk/oscom/product ... cts_id=111
Who is online
Users browsing this forum: No registered users and 9 guests