6.5x51 & 7.7x58 Japanese
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
bnz41
- Posts: 1990
- Joined: Sat Nov 06, 2010 4:20 pm
- Home club or Range: NRA Bisley
- Location: Essex
- Contact:
6.5x51 & 7.7x58 Japanese
Anyone reload these calibres if so any issues to look out for, see Kranks sell PPU brass for both these but not loaded ammo.
-
ukrifleman
- Full-Bore UK Supporter
- Posts: 757
- Joined: Thu Jun 07, 2012 7:26 pm
- Contact:
Re: 6.5x51 & 7.7x58 Japanese
I load cast and FMJ in both my T38 and T99 Arisaka's using PPU brass without any issues.
The only thing I would point out is, that you will notice a fair amount of bulge at the base of fired 6.5 brass which is normal, due to the way the case is supported by the bolt when in battery.
Both my rifles are accurate with the right load and are a pleasure to shoot.
ukrifleman.
The only thing I would point out is, that you will notice a fair amount of bulge at the base of fired 6.5 brass which is normal, due to the way the case is supported by the bolt when in battery.
Both my rifles are accurate with the right load and are a pleasure to shoot.
ukrifleman.
-
lasbrisas
Re: 6.5x51 & 7.7x58 Japanese
I load for both aswell, I doubt you will get loaded ammo apart from in the US. Advice I had was to not full length resize the 6.5 brass as the dies are not the correct SAAMI and you will knacker it ! I use a 6.5 swedish sizing die. For the 7.7 jap I use standard .303 174gr bullets and 6.5 139gr for the other. I was lucky enough to get Norma brass for both and do also have some ppu.
-
bnz41
- Posts: 1990
- Joined: Sat Nov 06, 2010 4:20 pm
- Home club or Range: NRA Bisley
- Location: Essex
- Contact:
Re: 6.5x51 & 7.7x58 Japanese
Many thanks both of you for the info.... 
Who is online
Users browsing this forum: No registered users and 3 guests