I have cut 7/8" x 14 tpi (teeth per inch) before with out any issues.
Not sure about 1- 5/64" x 16 tpi but I guess I will have to find out.
Lee Breech lock press
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
legs748
- Posts: 240
- Joined: Sat Jul 07, 2012 1:08 pm
- Home club or Range: Mattersey R&PC
- Location: North Nottinghamshire
- Contact:
Re: Lee Breech lock press
Teeth per inch? Are you broaching a rack?
It was working when i left it...........
Re: Lee Breech lock press
I was contemplating cutting a thread on the lathe for a part I was wanting to make. I have decided that it would probably not work for what I intended so I need to find another method.
-
legs748
- Posts: 240
- Joined: Sat Jul 07, 2012 1:08 pm
- Home club or Range: Mattersey R&PC
- Location: North Nottinghamshire
- Contact:
Re: Lee Breech lock press
I was referring to the fact that screws have thread, not teeth.
It was working when i left it...........
Re: Lee Breech lock press
Yes of course threads per inch I stand corrected. A senior moment.
Who is online
Users browsing this forum: No registered users and 5 guests