Source for Tempilaq?
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
Laurie
Re: Source for Tempilaq?
No. You can under-anneal, but not overdo it as far as the neck goes, well within reason anyway. The main risk in too much heat input is its migrating down the case body and softening the bottom of the case-body / case-head areas which you want to remain as hard as possible.
-
TattooedGun
- Posts: 2517
- Joined: Mon Jul 11, 2011 11:55 am
- Home club or Range: Dudley Rifle Club, UKPSA, Bromsgrove
- Location: West Midlands
- Contact:
Re: Source for Tempilaq?
Good stuff. knew about the case head, just didn't wanna turn the necks into limp noodles.Laurie wrote:No. You can under-anneal, but not overdo it as far as the neck goes, well within reason anyway. The main risk in too much heat input is its migrating down the case body and softening the bottom of the case-body / case-head areas which you want to remain as hard as possible.
-
phaedra1106
- Posts: 3429
- Joined: Wed Feb 08, 2012 9:37 pm
- Location: Just outside Sacriston (the nice bit!)
- Contact:
Re: Source for Tempilaq?
And remember the golden rule, regardless of what's written on the Internet, NEVER let a case neck start to glow, light red, dark red or "just barely glowing red in the dark under the covers with the lights off", once it's reached that point the next stage is to bin it!!! :)
There's room for all Gods creatures, next to the mash and gravy :)
Who is online
Users browsing this forum: No registered users and 5 guests