http://theswissriflesdotcommessageboard ... PDcAU1yZTs
Obviously these are maximum loads so it goes with out saying start lower and work up in the article it suggests 10% lower to start. Hope this helps Ill keep looking if I come up with anything else Ill post it. If you have any questions ask away. There are some very competent re loaders on here I'm sure one of them could help.
A burn rate chart for you to take a look at.
http://www.lapua.com/upload/reloading/r ... rt2011.pdf
Reloader 17 in the 6.5x55
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
BRYAN3
Re: Reloader 17 in the 6.5x55
I did see that artical earlier and think it might be worth a try starting at 38g with the 120g FMJ.
Re 17 and Re 19 are running level with Viht N150,roughly speaking in the burn rate chart.
My Viht manual shows starting load N150@36.3g and N160@44.7g for 120g Sierra HPBT.
Both those are shown for 140g which is my other 6.5 bullet that is expanding and not allowed on MOD ranges.
Bryan
Re 17 and Re 19 are running level with Viht N150,roughly speaking in the burn rate chart.
My Viht manual shows starting load N150@36.3g and N160@44.7g for 120g Sierra HPBT.
Both those are shown for 140g which is my other 6.5 bullet that is expanding and not allowed on MOD ranges.
Bryan
-
markyw
Re: Reloader 17 in the 6.5x55
Burn rate is one consideration, but pressure is another and the different powders may make very different pressures.
I am using RL 17 @ 36gr and find it accurate out to 100yds. Will be taking it to 200yds in a couple of weekends at Bisley, so we'll see how it does then. This is behind a PPU 139gr jacketed target bullet.
Regards
Mark
I am using RL 17 @ 36gr and find it accurate out to 100yds. Will be taking it to 200yds in a couple of weekends at Bisley, so we'll see how it does then. This is behind a PPU 139gr jacketed target bullet.
Regards
Mark
Who is online
Users browsing this forum: No registered users and 6 guests