One for ovenpaa,
A useful cartridge guide, load data, component advice, and much more;
http://www.accurateshooter.com/cartridge-guides/65x284
6.5-284 Cartridge Guide
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
spud
Re: 6.5-284 Cartridge Guide
easily done
powder 4831 sc 51.5 grains
bullet 140 amax
2890 fps or there abouts
job done
powder 4831 sc 51.5 grains
bullet 140 amax
2890 fps or there abouts
job done
Re: 6.5-284 Cartridge Guide
Many thanks Mark.
I picked up Lapua brass, 139 Lapua Scenar's, dies and a few other odds and ends today, I have my eyes on the Vikings stock of H4831SC and N560 as a workable alternative. I built a couple of dummy rounds just to get everything set up so I just need the COAL and we are ready to Rock 'n Roll
I anguished over the Scenar's versus Amax versus SMK's all of which look very good on paper and opted for Lapua first for no reason other than I have always liked the consistency of Lapua but that I will try the others over the next few weeks.
I picked up Lapua brass, 139 Lapua Scenar's, dies and a few other odds and ends today, I have my eyes on the Vikings stock of H4831SC and N560 as a workable alternative. I built a couple of dummy rounds just to get everything set up so I just need the COAL and we are ready to Rock 'n Roll
I anguished over the Scenar's versus Amax versus SMK's all of which look very good on paper and opted for Lapua first for no reason other than I have always liked the consistency of Lapua but that I will try the others over the next few weeks.
Who is online
Users browsing this forum: No registered users and 10 guests