Case Head Separation

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Post Reply
Message
Author
User avatar
dodgyrog
Posts: 4103
Joined: Wed Jan 05, 2011 11:17 pm
Home club or Range: Three Counties Sporting Club & Gardners Guns
Location: Consett, County Durham
Contact:
Contact dodgyrog

Re: Case Head Separation

#11 Post by dodgyrog »

dodgyrog wrote:
johngarnett wrote:If you have a bronze brush in say 45 cal, push it through the case and pull back against the neck? Worked for me once!
JohnG :cornwall:
I'll give that a go in the morning, good idea!
Thanks
Cerro next
Couldn't wait - the brush worked :goodjob:
Purveyor of fine cast boolits.
All round good guy and VERY grumpy old man.
Top
Post Reply

Return to “Reloading and Ammunition”

Who is online

Users browsing this forum: No registered users and 7 guests