I have some machine screws here with a major diameter of .133" x 40 TPI, can anyone identify them please. They are off an American produced set of 'scope rings. Closest I can find is .138x40 (No6x40) and these are too big, equally No5x40 is a tad small.
Can anyone help please?
Screw thread finder - .133x40
Moderator: dromia
Forum rules
Should your post be in Grumpy Old Men? This area is for general shooting related posts only please.
Should your post be in Grumpy Old Men? This area is for general shooting related posts only please.
-
R.G.C
Re: Screw thread finder - .133x40
David,ovenpaa wrote:I have some machine screws here with a major diameter of .133" x 40 TPI, can anyone identify them please. They are off an American produced set of 'scope rings. Closest I can find is .138x40 (No6x40) and these are too big, equally No5x40 is a tad small.
Can anyone help please?
Are they not simply M3:5 x 0,60?
They are so close to #6-40 that thy are easily cpnfused.
Qualified as 'limited use' , they were and are probably still widely used in german optic industry.
R.G.C
Re: Screw thread finder - .133x40
Robert, I tried a couple of M3.5x0,6 screws and they are too tight. As they have come off a set of rings of USA origin I suspect they might be No6-40 screws that are at the bottom end of limit on the major diameter.
Re: Screw thread finder - .133x40
Yes 6x40TPI, I am really chuffed, I ordered them last night and they arrived today, are fitted and will head off to the customer in the morning ready for him to shoot a competition at the end of the month.
Re: Screw thread finder - .133x40
Nice one.
Who is online
Users browsing this forum: No registered users and 6 guests