![Image](http://img."An application".com/d/14/04/05/ema5azeg.jpg)
Sent from my Transformer TF101 using "An application"
Help to identify unknown parts.
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
fred2892
Help to identify unknown parts.
These bits came in an auction lot. Can anyone identify them? Similar in appearance to 'm' die expanders, but they are not threaded at all. Cant match them up to anything in the redding catalogue (assuming they belong in the redding bag). Both measure .3655" on the shank.
Sent from my Transformer TF101 using "An application"
Sent from my Transformer TF101 using "An application"
Re: Help to identify unknown parts.
I can't say I've seen these before but my guess would be a case neck gauge.
http://www.midwayuk.com/epages/Midway_U ... se%20gauge
http://www.ar15.com/mobile/topic.html?b=6&f=37&t=409548
Edit: 9.3mm (.365) being not a particularly unusual calibre.
http://www.midwayuk.com/epages/Midway_U ... se%20gauge
http://www.ar15.com/mobile/topic.html?b=6&f=37&t=409548
Edit: 9.3mm (.365) being not a particularly unusual calibre.
Who is online
Users browsing this forum: No registered users and 8 guests