Bullet mould manfacturer needed
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Re: Bullet mould manfacturer needed
I would be interested to see a picture to see how complex a form it is. What is really needed is the shrinkage % to know how far over to machine the mould.
-
ukrifleman
- Full-Bore UK Supporter
- Posts: 756
- Joined: Thu Jun 07, 2012 7:26 pm
- Contact:
Re: Bullet mould manfacturer needed
Previous post edited with picture.
ukrifleman.
ukrifleman.
Who is online
Users browsing this forum: No registered users and 5 guests