75 Grain Amax seating depth

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Post Reply
Message
Author
Dannywayoflife

Re: 75 Grain Amax seating depth

#11 Post by Dannywayoflife »

Ok I'll give that a try. I used a lightly neck sized case and allowed the lands to seat the bullet to find them.
Top
Eric S

Re: 75 Grain Amax seating depth

#12 Post by Eric S »

I don't load for 223 but I've heard 0.02 of the lands is a good place to start, magazine permitting
Top
Dannywayoflife

Re: 75 Grain Amax seating depth

#13 Post by Dannywayoflife »

Eric S wrote:I don't load for 223 but I've heard 0.02 of the lands is a good place to start, magazine permitting
Mag isn't a problem for me mate as I'm running a chassis and AI mags so can seat to over 2.5" and still fit in the mag.
Top
Post Reply

Return to “Reloading and Ammunition”

Who is online

Users browsing this forum: No registered users and 8 guests