Necking up 6.5x284 brass into 284 win 7mm.
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
ranger4
Necking up 6.5x284 brass into 284 win 7mm.
What expander and neck bushings sizes are you guys using to neck up 6.5x284 into 284 win brass and what process do you follow, thanks.
-
Geordie bloke
Re: Necking up 6.5x284 brass into 284 win 7mm.
Hi, I use a Sinclair 7mm neck expander with a bit of imperial wax lube on the mandrel on my Lapua 6.5 x 284 cases and it does it in one go with no problems.
As I have a 284 Shehane tight neck I have to turn my necks to 13 thou thick to give a loaded round of .310 as my chamber neck is 0.313.
I use a .307 bushing to give me 2 thou bullet retention and all is good with my load.
As I have a 284 Shehane tight neck I have to turn my necks to 13 thou thick to give a loaded round of .310 as my chamber neck is 0.313.
I use a .307 bushing to give me 2 thou bullet retention and all is good with my load.
-
John25
Re: Necking up 6.5x284 brass into 284 win 7mm.
Ditto the kit, I anneal the cases first if I have previously used them in my 6.5 as they are prone to split.
-
spud
Re: Necking up 6.5x284 brass into 284 win 7mm.
i have kits for this job on the shelf if you need any thing in all calibres
i too have a tight neck shehane but am getting away with a 311 neck and 2 thou neck clearance
i too have a tight neck shehane but am getting away with a 311 neck and 2 thou neck clearance
Who is online
Users browsing this forum: No registered users and 12 guests