Does anyone make the PID's ( temp controller) for Lee melting pot here in the the UK?
I need one as some times I'm overheating my lead for casting and need alot more control as the pot starts to lower capacity.
Thank you
Wanted:PID device for a Lee 4-10 melting pot
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
-
dromia
- Site Admin
- Posts: 19991
- Joined: Sat Nov 06, 2010 4:57 am
- Home club or Range: The Highlands of Scotland. Cycling Proficiency 1964. Felton & District rifle club. Teesdale Pistol and Rifle club.
- Location: Sutherland and Co Durham
- Contact:
Re: Wanted:PID device for a Lee 4-10 melting pot
I made my own, plenty of instructions available online and the parts are easily obtainable at lest they were when I did it 15 years ago.
It isn't at all difficult as evidenced by the fact that I managed it.
It isn't at all difficult as evidenced by the fact that I managed it.
Come on Bambi get some
Imperial Good Metric Bad
Analogue Good Digital Bad
Fecking stones
Real farmers don't need subsidies
Cow's farts matter!
For fine firearms and requisites visit
http://www.pukkabundhooks.com/
-
dromia
- Site Admin
- Posts: 19991
- Joined: Sat Nov 06, 2010 4:57 am
- Home club or Range: The Highlands of Scotland. Cycling Proficiency 1964. Felton & District rifle club. Teesdale Pistol and Rifle club.
- Location: Sutherland and Co Durham
- Contact:
Re: Wanted:PID device for a Lee 4-10 melting pot
Just a thought but it might be an option to look at a larger pot.
My 40 lb dipping pot has built in PID but it rarely kicks in, I usually cast about 1/2 the pot at a time around 20 lbs and the temperature stays pretty much spot on start going below that and the PID starts working more.
My 40 lb dipping pot has built in PID but it rarely kicks in, I usually cast about 1/2 the pot at a time around 20 lbs and the temperature stays pretty much spot on start going below that and the PID starts working more.
Come on Bambi get some
Imperial Good Metric Bad
Analogue Good Digital Bad
Fecking stones
Real farmers don't need subsidies
Cow's farts matter!
For fine firearms and requisites visit
http://www.pukkabundhooks.com/
Who is online
Users browsing this forum: No registered users and 2 guests