Loads for .243 for deer hunting

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Message
Author
crismaqsood
Posts: 32
Joined: Mon Feb 27, 2023 11:21 pm
Home club or Range: NRA
Location: Telford
Contact:

Loads for .243 for deer hunting

#1 Post by crismaqsood »

Hello all

I'm just starting reloading my own ammo and I would appreciate if any of you had some pointers on a good powder/bullet for deer hunting.

I do have a couple of reloading books but nothing like advice from people that actually shoot ☺️

Thank you in advance
User avatar
dromia
Site Admin
Posts: 19995
Joined: Sat Nov 06, 2010 4:57 am
Home club or Range: The Highlands of Scotland. Cycling Proficiency 1964. Felton & District rifle club. Teesdale Pistol and Rifle club.
Location: Sutherland and Co Durham
Contact:

Re: Loads for .243 for deer hunting

#2 Post by dromia »

What type of deer?

Pressure tested data from handloading manuals and powder manufacturers should always be your first port of call and never vary from the recommended minimum and maximum loads, if sources disagree then always go with the lowest. Always be sure the publisher has pressure tested the data. Never trust plagiarised data like Lee do in their worthless tome.

Vihtavuori N160 under a Hornady FBSP 100 gn Interlock does it for me, use Vihtavuori data and work up accuracy load from minimum recommended. Do not exceed maximum recommended.

Same load works equally well in my .243"s and my 6mm Musgrave.

To be honest though I far prefer the .303" and the .270" when it comes to the reds.

To my mind the .243" is almost a hinds rifle or less.
Image

Come on Bambi get some

Imperial Good Metric Bad
Analogue Good Digital Bad

Fecking stones

Real farmers don't need subsidies

Cow's farts matter!

For fine firearms and requisites visit

http://www.pukkabundhooks.com/
User avatar
Graham M
Full-Bore UK Supporter
Posts: 960
Joined: Sun Nov 07, 2010 1:14 pm
Location: Brum
Contact:

Re: Loads for .243 for deer hunting

#3 Post by Graham M »

I used to be able to buy H414 for .243 Still have some but you can't get it anymore due to REACH banning it. With the right bullet placement a .243 and a 105grn will drop any deer and I have shot Fallow with one, although that was only because we were after Roe and a Fallow came onto the scene. Mostly I use my .308.
A lot depends on your rifle as some .243 won't stabilise a 105grn bullet.........and some will. My Tikka T3 will.
Best thing to do is try out some heavier bullets or see if someone will give you a couple of rounds of ammo to try out.
Never argue with an idiot, he will drag you down to his level and beat you with experience.
dta europe
Posts: 88
Joined: Thu Dec 30, 2010 12:28 pm
Location: Northampton UK
Contact:

Re: Loads for .243 for deer hunting

#4 Post by dta europe »

I would heartily recommend RL 22 and the Nosler 95 gr ballistic tip. If anything this combination can be too efficient on game. It is also likely to stabilise well in your rifle as the standard .243 twist off the shelf is in my opinion this calibres only negative.

Ewen
User avatar
dodgyrog
Posts: 4097
Joined: Wed Jan 05, 2011 11:17 pm
Home club or Range: Three Counties Sporting Club & Gardners Guns
Location: Consett, County Durham
Contact:

Re: Loads for .243 for deer hunting

#5 Post by dodgyrog »

I believe that lead free bullets are required for deer stalking. That being the case I do not believe the .243 can be made to use said bullets to meet the power/velocity requirements.
Get yourself a nice second hand 6,5x55 or 30-06
Purveyor of fine cast boolits.
All round good guy and VERY grumpy old man.
User avatar
Graham M
Full-Bore UK Supporter
Posts: 960
Joined: Sun Nov 07, 2010 1:14 pm
Location: Brum
Contact:

Re: Loads for .243 for deer hunting

#6 Post by Graham M »

Lead free bullets are only required if they are going into the public food chain. If you are using the meat for personal use then you can still use lead bullets.
Never argue with an idiot, he will drag you down to his level and beat you with experience.
User avatar
Alpha1
Posts: 8558
Joined: Fri Nov 12, 2010 8:27 pm
Contact:

Re: Loads for .243 for deer hunting

#7 Post by Alpha1 »

Graham M wrote: Thu Mar 16, 2023 5:10 pm Lead free bullets are only required if they are going into the public food chain. If you are using the meat for personal use then you can still use lead bullets.
And how long do you think that will last before they change the rules.
User avatar
Graham M
Full-Bore UK Supporter
Posts: 960
Joined: Sun Nov 07, 2010 1:14 pm
Location: Brum
Contact:

Re: Loads for .243 for deer hunting

#8 Post by Graham M »

I'm fully aware of that, but at the moment I was giving live information not conjecture.
Never argue with an idiot, he will drag you down to his level and beat you with experience.
User avatar
dodgyrog
Posts: 4097
Joined: Wed Jan 05, 2011 11:17 pm
Home club or Range: Three Counties Sporting Club & Gardners Guns
Location: Consett, County Durham
Contact:

Re: Loads for .243 for deer hunting

#9 Post by dodgyrog »

Further to mhy comment above I have found that most .243 rifles with standard twist barrels will not stabilise 100gr bullets that are required for deer hunting. Correct me if I am wrong. I am thinking of Roe and bigger deer in this instance.
Purveyor of fine cast boolits.
All round good guy and VERY grumpy old man.
User avatar
dromia
Site Admin
Posts: 19995
Joined: Sat Nov 06, 2010 4:57 am
Home club or Range: The Highlands of Scotland. Cycling Proficiency 1964. Felton & District rifle club. Teesdale Pistol and Rifle club.
Location: Sutherland and Co Durham
Contact:

Re: Loads for .243 for deer hunting

#10 Post by dromia »

The 100gn interlocks work in my older model .243"s. Mauser Model 66, Parker Hale and the Musgrave Springbok rifle in 6mm Musgrave. You need the flat based ones not the boattail as they don't stabilise too well must just be that smidgeon too long for the twist.

They are ok for Roe but if I am going for anything larger then a heavier bullet/calibre would be my choice.

The .243 will kill reds with proper shot placement, so will a .22 rimfire but that doesn't mean it should be the round of choice, as well as being illegal. There are just so many variables in the field that I like as much of an extra margin as I can get in proportion to the quarry.

As a well known big game hunter said when he was asked why he used to .600" Nitro express, at that time the most powerful commercial round available, he answered "because I can't get anything bigger"!
Image

Come on Bambi get some

Imperial Good Metric Bad
Analogue Good Digital Bad

Fecking stones

Real farmers don't need subsidies

Cow's farts matter!

For fine firearms and requisites visit

http://www.pukkabundhooks.com/
Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests