Chiappa Rhino Speed Loader - Dims needed
Posted: Mon Feb 06, 2023 12:58 pm
Hi All
I am soon to buy a Chiappa Rhino LBR in .357Mag, so I am currently designing a speed loader for one. This will be a simple 3D print job but should hopefully do the trick.
Would someone mind helping me out with a couple of dimensions? If not I will have to wait until I have one so I can measure it myself.
1. Across flats size of the hexagonal "cylinder" body.
2. Distance between 2 opposite chambers. Either outside edge to outside edge, along with the chamber bore diameter; or center to center if you can.
Very rough mock up of design below.
I am soon to buy a Chiappa Rhino LBR in .357Mag, so I am currently designing a speed loader for one. This will be a simple 3D print job but should hopefully do the trick.
Would someone mind helping me out with a couple of dimensions? If not I will have to wait until I have one so I can measure it myself.
1. Across flats size of the hexagonal "cylinder" body.
2. Distance between 2 opposite chambers. Either outside edge to outside edge, along with the chamber bore diameter; or center to center if you can.
Very rough mock up of design below.