10 bore blanks

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Post Reply
Message
Author
User avatar
Dellboy
Posts: 2619
Joined: Wed Aug 31, 2011 11:49 am
Home club or Range: Star Shooting Club
Location: Essex
Contact:

10 bore blanks

#1 Post by Dellboy »

have been asked to load some blanks for a sailing club

apparently 10 bore are difficult to get ?

so anyone got any recipes ?

thinking black powder or a substitute for the noise but how much ?

wads felt or card ?

thanks
2020 GOOD DEALS WITH

Cutch Vortex Scope
Mauserbill Enfield Books


Enjoy today as tomorrow might not come .

Noli pati a scelestis opprimi.

002515
User avatar
450 Martini
Posts: 316
Joined: Tue May 14, 2013 11:28 pm
Home club or Range: Swadlincote RPC
Contact:

Re: 10 bore blanks

#2 Post by 450 Martini »

Black powder works best with large calibre shotgun blanks.
A card wad sealed in with glue is normally sufficient but a heavy wad will increase pressure and therefore noise. If the sailing club has a spare round to show you reproducing it should be fairly simple.
These shells are loaded to just over 200 grains or 8 drams. https://www.perfectshotllc.com/product/ ... ith-smoke/
I'd start lower, make up a few prototypes and test them until the desired noise level is reached.
Blanks of any kind have become difficult to find recently, even .303 is approaching £1 a round.
Post Reply

Who is online

Users browsing this forum: No registered users and 0 guests