Pulling...

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Post Reply
Message
Author
User avatar
bradaz11
Sporadic Site Supporter
Posts: 4714
Joined: Mon Jun 02, 2014 1:23 am
Home club or Range: The tunnel at Charmouth, BWSS
Location: Bristol
Contact:

Pulling...

#1 Post by bradaz11 »

Just a few cartridges to pull. Given up putting it off

IMG_20220627_191916.jpg
When guns are outlawed, only Outlaws will have guns
PeterN
Posts: 344
Joined: Tue Sep 22, 2020 8:08 am
Contact:

Re: Pulling...

#2 Post by PeterN »

What is wrong with them?
Regards
Peter.
User avatar
bradaz11
Sporadic Site Supporter
Posts: 4714
Joined: Mon Jun 02, 2014 1:23 am
Home club or Range: The tunnel at Charmouth, BWSS
Location: Bristol
Contact:

Re: Pulling...

#3 Post by bradaz11 »

As far as i can tell, they've been reloaded as 38spl. It looks like 3gr of bullseye behind 158 and 150gr swc's

38s&w shows 2.2gr of bullseye to be Max load in my manual

Other thing I've noticed while pulling, i think they've been thru spl dies as the case is measuring 381 not 386 ISH. And a case will just about for my 38spl case checker but my brass won't come anywhere near to fitting
When guns are outlawed, only Outlaws will have guns
Post Reply

Who is online

Users browsing this forum: No registered users and 14 guests