N550 loads for 174 / 180 gr .303

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Message
Author
Victory Glow

N550 loads for 174 / 180 gr .303

#1 Post by Victory Glow »

Hi,
I use N550 with a Lapua Lockbase 150gr bullet for reloading for my 30-06. According to Vihtavuori, N540 can be used to reload 303 but not N550. Has anyone worked up a load for the 303 using N550, or is it just too slow burning to be useful? Normally I use N135 for my 303, so just wondering.
Thanks,
VG
User avatar
Alpha1
Posts: 8628
Joined: Fri Nov 12, 2010 8:27 pm
Contact:

Re: N550 loads for 174 / 180 gr .303

#2 Post by Alpha1 »

I have only ever used N140 for my .303,s.
User avatar
ovenpaa
Posts: 24689
Joined: Fri Nov 05, 2010 8:27 pm
Location: Årbjerg, Morsø DK
Contact:

Re: N550 loads for 174 / 180 gr .303

#3 Post by ovenpaa »

N540 and N550 are double base powders and not something I would consider for an ageing .303 so as above, N140 is my preferred choice with the 174SMK for the 303.
/d

Du lytter aldrig til de ord jeg siger. Du ser mig kun for det tøj jeg har paa ...

Shed Journal
User avatar
WelshShooter
Full-Bore UK Supporter
Posts: 1812
Joined: Wed Jun 25, 2014 9:45 pm
Contact:

Re: N550 loads for 174 / 180 gr .303

#4 Post by WelshShooter »

The N5xx series of Viht powders are double base and quite energetic so I wouldn't reccomend using it with milsurp rifles if you want to prevent throat erosion etc.

That being said, I found Reload Swiss RS60 to work well with 180gr S&B bullets (if you check the burn rate chart on Reload Swiss website you'll see it's similar to N550) until I realised that that too was a double base powder. Now I stick with N140 and 180gr S&B bullets and achieve fantastic results. 38.5gr with new cases or 39.7gr with fired cases which have been shoulder bumped. Haven't loaded 174gr in years.

Note: your mileage may vary, even though the above load is "in spec" always work with published load data.
User avatar
ovenpaa
Posts: 24689
Joined: Fri Nov 05, 2010 8:27 pm
Location: Årbjerg, Morsø DK
Contact:

Re: N550 loads for 174 / 180 gr .303

#5 Post by ovenpaa »

I preferred RS50 or as was TR140 for .303 when shooting my 4(T) out to 1000 yards. Recently I have been using Varget and H-4895 with OK results. The .303 always seems to be more velocity sensitive than powder sensitive to me.
/d

Du lytter aldrig til de ord jeg siger. Du ser mig kun for det tøj jeg har paa ...

Shed Journal
User avatar
WelshShooter
Full-Bore UK Supporter
Posts: 1812
Joined: Wed Jun 25, 2014 9:45 pm
Contact:

Re: N550 loads for 174 / 180 gr .303

#6 Post by WelshShooter »

Yeah I tried TR140 and RS50 eventually when it came out but I didn't really get on with it. Probably due to the poor 174gr ppu bullets I was using at the time. That reminds me, I have a couple of boxes of SMK's I never got around to trying. As I understand, RS50 is essentially an "improved" N140 since they use the same recipe with some minor changes (if I recall from an old thread from Laurie).

Do you see any noticeable improvement using this powder over N140? One improvement I see is cleaning of cases in tumbler, the viht powder comes off easily whereas the Reload Swiss kinda bakes on the outside case necks and requires IPA/meth spirits on a cloth to physically remove it. I don't like putting dirty cases through my sizing dies.
User avatar
ovenpaa
Posts: 24689
Joined: Fri Nov 05, 2010 8:27 pm
Location: Årbjerg, Morsø DK
Contact:

Re: N550 loads for 174 / 180 gr .303

#7 Post by ovenpaa »

Yes, the RS/TR is a bit dirtier, I invariably load low unless it is for longer distances, so around 39.9 through to 40.3 dependant on which rifle with TR140, which always seemed a tad slower than N140. I did like TR140. Varget and 4895 both work well as an alternative. Having said that, I heard of Varget being advertised for £75.00 a tub (1lb) start of this year. Being non REACH compliant it is never going to come back in so existing stock must be thin on the ground. Luckily I have a bit as I also use it in my 22-250

Most recently I have been reloading with 180 Spitzer's I picked up some ages ago and found two bags on a shelf above my desk.
/d

Du lytter aldrig til de ord jeg siger. Du ser mig kun for det tøj jeg har paa ...

Shed Journal
User avatar
snayperskaya
Posts: 7234
Joined: Fri Oct 04, 2013 6:43 pm
Home club or Range: West Bank of the Volga.....
Location: West of The Urals
Contact:

Re: N550 loads for 174 / 180 gr .303

#8 Post by snayperskaya »

Anyone use Ramshot Big Game and/or Alliant RL-15 for .303?.
"The only real power comes out of a long rifle." - Joseph Stalin

Give a man a gun and he can rob a bank.....give a man a bank and he can rob the world!.

More than a vested interest in 7.62x54r!
User avatar
ovenpaa
Posts: 24689
Joined: Fri Nov 05, 2010 8:27 pm
Location: Årbjerg, Morsø DK
Contact:

Re: N550 loads for 174 / 180 gr .303

#9 Post by ovenpaa »

Not here.
/d

Du lytter aldrig til de ord jeg siger. Du ser mig kun for det tøj jeg har paa ...

Shed Journal
User avatar
Alpha1
Posts: 8628
Joined: Fri Nov 12, 2010 8:27 pm
Contact:

Re: N550 loads for 174 / 180 gr .303

#10 Post by Alpha1 »

No I have only ever used 41 grains of N140 with a flat based bullet. It just works.
Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests