Question for David

'Something shiny from the SHED' - A range of shooting and reloading accessories designed and built here in the UK.
Post Reply
Message
Author
User avatar
Alpha1
Site Supporter Since 2020
Posts: 8553
Joined: Fri Nov 12, 2010 8:27 pm
Contact:

Question for David

#1 Post by Alpha1 »

Hope you don't mind me asking please remove the thread if it's not appropriate. Carbide inserts tool holders are they hardened is it possible to mill a 16mm holder down to 14mm to fit in my quick change tool post holder. I prefer to use the 16mm inserts. I have several holders that will fit in my tool post and accept the 16mm inserts but they were machined for me by an old guy in the now defunct machine shop. He has retired at 73 and the machine shop is gone.
I ordered a boatload of VNMG 16MM inserts thinking they would fit my tool holder and they don't so I have bought a suitable tool holder but its 16mm and it won't fit in my tool post holder.
Hope that makes sense. kukkuk
User avatar
bradaz11
Sporadic Site Supporter
Posts: 4714
Joined: Mon Jun 02, 2014 1:23 am
Home club or Range: The tunnel at Charmouth, BWSS
Location: Bristol
Contact:

Re: Question for David

#2 Post by bradaz11 »

tool holders are usually soft, take a file to it and see
When guns are outlawed, only Outlaws will have guns
User avatar
Ovenpaa
Site Supporter Since 2015
Posts: 24680
Joined: Fri Nov 05, 2010 8:27 pm
Location: Årbjerg, Morsø DK
Contact:

Re: Question for David

#3 Post by Ovenpaa »

Yes they are soft (ish) Just bung the tool in the mill and take a couple of mil off the top along the clamping area so it fits correctly in the tool holder. This way you do not have to worry about cutting at a slight angle and upsetting the tool geometry.

Sequence: The insert goes in the tool which goes in the tool holder which goes in the tool post.

Personally I would have suggested the DCGT11 even though I use the VCGT16 almost exclusively in the bigger machines in straight, left and right hand configurations, for me, the VCGT profile is slightly better suited to some jobs.
/d

Du lytter aldrig til de ord jeg siger. Du ser mig kun for det tøj jeg har paa ...

Shed Journal
User avatar
Alpha1
Site Supporter Since 2020
Posts: 8553
Joined: Fri Nov 12, 2010 8:27 pm
Contact:

Re: Question for David

#4 Post by Alpha1 »

Didnt have any luck even with carbides I dont normally use these inserts I bought them by mistake.
I either stick them on the bay or make a tool post holder that will acept a 16mm tool.

Making a tool holder sounds like a project for the week end.
teanews
User avatar
Alpha1
Site Supporter Since 2020
Posts: 8553
Joined: Fri Nov 12, 2010 8:27 pm
Contact:

Re: Question for David

#5 Post by Alpha1 »

I checked I already have DCGT11 inserts and right and left hand insert tool holders. I just prefer the 16mm jobbies. Listen to me it's not that long ago I didn't even know what a carbide insert was never mind understand the numbering.
User avatar
Alpha1
Site Supporter Since 2020
Posts: 8553
Joined: Fri Nov 12, 2010 8:27 pm
Contact:

Re: Question for David

#6 Post by Alpha1 »

I took the carbide tool holder to work and popped it in the Bridgeport Mill it went through it like a hot knife through butter. Job done.
Post Reply

Who is online

Users browsing this forum: No registered users and 6 guests