Bullet feeder for Lee progressive press
Posted: Sun Oct 29, 2017 10:31 pm
Hi
I have a bullet feeder kit which I find works pretty well for my M1 carbine, as long as a bit of care is taken. I'd like to purchase a feed die kit to do .38spl/.375mag. Lee list either a 9mm/.365" or a .40" set. My initial thought was to go for the 9mm and use a Dremel to open it up slightly if it was too tight.
Has anyone any experience of which would be the better choice?
Cheers
Donald
I have a bullet feeder kit which I find works pretty well for my M1 carbine, as long as a bit of care is taken. I'd like to purchase a feed die kit to do .38spl/.375mag. Lee list either a 9mm/.365" or a .40" set. My initial thought was to go for the 9mm and use a Dremel to open it up slightly if it was too tight.
Has anyone any experience of which would be the better choice?
Cheers
Donald
