Page 2 of 4

Re: Cannon anyone?

Posted: Sun Sep 10, 2017 10:40 am
by Hrun
Triffid wrote:Do these go on s SGC or FAC ?

Triffid
FAC as they are sub 24 inch I believe

Re: Cannon anyone?

Posted: Sun Sep 10, 2017 12:40 pm
by dromia
Correct, although smooth bore the barrel length makes them section 1.

Re: Cannon anyone?

Posted: Sun Sep 10, 2017 5:58 pm
by meles meles
Picks up teffylone.

" 'ello. Mystic Meg? It is ? Good. Badger 'ere. Yes, of course you knew that... Do you have a sister by the name of Mons ?"

Image

Re: Cannon anyone?

Posted: Sun Sep 10, 2017 6:12 pm
by Ovenpaa
Well we had a terrific morning at NCB. As part of the Baikal challenge the little cannon was set up with members charged GBP2.00 per shot so costs covered plus a little bit for the club. The Viking and I manned the cannon so to speak and the members assisting in loading then sighting and firing the cannon at a splendid model of a Frenchie.

Points were awarded for shot placement with the maximum score being awarded for a hit on the magazine marked just forward of the middle mast and just above the waterline. We started at just after 10:00 and did not stop until close of play at a couple of minutes before 13:00 and I was impressed both by the take up by people with queues at a couple of points, plus the accuracy was for the most very good with the magazine being hit on a couple of occasions. All in all a great morning and the cannon only rolled off the table on one occasion :)
IMG_2086.jpg

Re: Cannon anyone?

Posted: Sun Sep 10, 2017 6:18 pm
by Les
What do you put on the variation form for "Reason etc" ?

Re: Cannon anyone?

Posted: Sun Sep 10, 2017 6:40 pm
by Christel

Re: Cannon anyone?

Posted: Sun Sep 10, 2017 6:59 pm
by DanTheMan
We used a 2 pounder today to scatter the ashes of one of our club members downrange.

Image

Re: Cannon anyone?

Posted: Sun Sep 10, 2017 7:36 pm
by bradaz11
Les wrote:What do you put on the variation form for "Reason etc" ?
target

Re: Cannon anyone?

Posted: Mon Sep 11, 2017 7:25 am
by dromia
I use some stout string taken round the trunions and tied to a hook that goes over the edge of the table to stop my cannon recoiling off the table

Re: Cannon anyone?

Posted: Mon Sep 11, 2017 7:56 am
by Blackstuff
So if you can own one on an FAC you're free of the 2" bore diameter restriction having it on your SGC?