Can anyone tell me if the little plastic ends on the primer tube magazines for the Dillon 650 and 1050 are the same dimensionally? The primer tubes (magazine)on the RL-1000 appear to be designed for slightly different ends which I cannot source and mine are worn out in that the primers either fall out or there is so much resistance that the do not feed despite the follower being fitted and in good condition.
I could always add some more weight to the follower however I am still going to struggle to find end caps so the best way forward is to modify/rebuild the primer station to accept the later type primer magazine tubes and make my life a lot easier unless someone has any alternative suggestions.
Anyone?
Dillon press primer pickup tubes
Moderator: dromia
Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.
Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Re: Dillon press primer pickup tubes
Sorted now, many thanks Mark
Who is online
Users browsing this forum: No registered users and 4 guests