Page 1 of 1
Carbide inserts.
Posted: Thu Oct 20, 2016 11:32 pm
by Alpha1
Do you use a facemill on your Milling machine in the shed. I have boxes of carbide inserts of various kinds that are destined for the scrap skip. Wondered if any of them would be of use to you. I will put up some codes to morrow if you can use them great. If not they will go in the skip.
Re: Carbide inserts.
Posted: Fri Oct 21, 2016 5:54 am
by Ovenpaa
I do use face mills with inserts :)
Re: Carbide inserts.
Posted: Fri Oct 21, 2016 3:41 pm
by Alpha1
2 BOXES 8 in EACH of sandvik parting off tips N151-26008-60-5T
1 BOX OF 10 APKT-1003 PDR-H-NK135
1 BOX OF 10 APKT-1604PDR-HM-IC328
1 BOX OF 10 WCMX-050308-NN
1 BOX OF 10 ZXMT09T306GM
1 BOX OF 10 XNKT080508PNSR-MM
SOME 20MM TRIANGULAR THREE CUTTING FACES INSERTS.
NGD4189LK
TNMM-220408-65
A PART BOX OF SANDVIK LCMX-04-03-08-53
A PART BOX 7 PIECES 12MM ROUND PROFILING INSERTS 03695 SM25 RNMG 120400 10
BITS AND PECES 16MM CUTTING EDGE
KENAMETAL DSN-432 CO6O13 01-91-01 MR
TAEGUTEC LSD 42
TAEGUTEC SSV 32
These are all surplus to requirements I have put the ones I'm interested in to one side. There are lots more but I'm not sure what the rest of them are for. They have come from a machine shop that the Company has shut down everything else has been re located or auctioned off. These are destined for the scrap bin. If any thing is of use let me know.
Re: Carbide inserts.
Posted: Fri Oct 21, 2016 4:32 pm
by Ovenpaa
Hmm... there is nothing that I recognise for face cutters however there are some parting off inserts, it is a shame you do not have the tool holders to suit.
Re: Carbide inserts.
Posted: Fri Oct 21, 2016 6:54 pm
by Alpha1
The parting of inserts are to big for my tooling I think they are 5mm you are welcome to them if you can use them otherwise they will go in the skip with the rest of them.