Varmint Grenade

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Message
Author
User avatar
ovenpaa
Posts: 24689
Joined: Fri Nov 05, 2010 8:27 pm
Location: Årbjerg, Morsø DK
Contact:

Varmint Grenade

#1 Post by ovenpaa »

I have been given most of a box of 50 grain Barnes Varmint Grenade's - Does anyone have any thoughts on them, are they as good as the internet claims?
/d

Du lytter aldrig til de ord jeg siger. Du ser mig kun for det tøj jeg har paa ...

Shed Journal
User avatar
Sim G
Posts: 10752
Joined: Sat Nov 06, 2010 9:09 pm
Contact:

Re: Varmint Grenade

#2 Post by Sim G »

No, not used them, but have heard that these are not regarded as "s5 expanding" but s1/unrestricted as they do not "expand" predictably as they tend to disintegrate....
In 1978 I was told by my grand dad that the secret to rifle accuracy is, a quality bullet, fired down a quality barrel..... How has that changed?

Guns dont kill people. Dads with pretty Daughters do...!
User avatar
shotgun sam
Posts: 542
Joined: Mon Jan 30, 2012 6:42 pm
Location: South Lanarkshire, Scotland
Contact:

Re: Varmint Grenade

#3 Post by shotgun sam »

I tried the 36 grains ones a few years ago when I visiting a friend in Fife when we went out after foxes they did the job all right
mossberg 500
meteor mk2
smk 19 (0.22)
ruger 12/22 stainless synthetic 22lr
cz 452 style 16 inch 22lr
tikka t3 lite stainless 223
308 howa 1500 varmint
BSA Lightning XL (0.22)
Lanber Over and Under
Baikal mp153
AYA Cosmos 410
1917 BSA SMLE 303
User avatar
ovenpaa
Posts: 24689
Joined: Fri Nov 05, 2010 8:27 pm
Location: Årbjerg, Morsø DK
Contact:

Re: Varmint Grenade

#4 Post by ovenpaa »

They are deemed to be expanding at a fairly local Gunshop, personally I have no experience of them, in fact I am not even sure who brings then into the country. I will load a few up and see how they go.
/d

Du lytter aldrig til de ord jeg siger. Du ser mig kun for det tøj jeg har paa ...

Shed Journal
User avatar
DL.
Posts: 1634
Joined: Tue Jun 21, 2011 11:24 am
Contact:

Re: Varmint Grenade

#5 Post by DL. »

As I understand it the copper/tin bullet construction means for a longer bullet than a lead one, if your .22/250 is 1:14 then results may not be optimal.
User avatar
ovenpaa
Posts: 24689
Joined: Fri Nov 05, 2010 8:27 pm
Location: Årbjerg, Morsø DK
Contact:

Re: Varmint Grenade

#6 Post by ovenpaa »

They do seem to have a reasonably long bearing surface from a visual inspection and a quick Google does suggest a 1:9 twist is necessary. Time for the calculator to confirm things...
/d

Du lytter aldrig til de ord jeg siger. Du ser mig kun for det tøj jeg har paa ...

Shed Journal
User avatar
ovenpaa
Posts: 24689
Joined: Fri Nov 05, 2010 8:27 pm
Location: Årbjerg, Morsø DK
Contact:

Re: Varmint Grenade

#7 Post by ovenpaa »

Just checked, Millers shows the stability factor (SG) as around 0.645 so they are going to be unstable with a 1:14 even at 3,925fps. one minor plus side is they are flat based and Millers does not really take this into account however I doubt the flat base will pull the SG to anything reasonable. Thanks for pointing that out DL.
/d

Du lytter aldrig til de ord jeg siger. Du ser mig kun for det tøj jeg har paa ...

Shed Journal
Chapuis
Posts: 1676
Joined: Tue Dec 28, 2010 11:32 am
Contact:

Re: Varmint Grenade

#8 Post by Chapuis »

Sim G wrote:No, not used them, but have heard that these are not regarded as "s5 expanding" but s1/unrestricted as they do not "expand" predictably as they tend to disintegrate....
You have been misinformed there Sim G as they are a varmint bullet and super "explosive" originaly intended for ground squirrels or so I understand.
Perhaps because of their extensive expansion someone though they should be regarded as frangible? They are however definitely section 5 not section 1.
User avatar
Sandgroper
Full-Bore UK Supporter
Posts: 4735
Joined: Sat Nov 06, 2010 3:45 pm
Location: Stanley, Falkland Islands
Contact:

Re: Varmint Grenade

#9 Post by Sandgroper »

Chapuis wrote:
Sim G wrote:No, not used them, but have heard that these are not regarded as "s5 expanding" but s1/unrestricted as they do not "expand" predictably as they tend to disintegrate....
You have been misinformed there Sim G as they are a varmint bullet and super "explosive" originaly intended for ground squirrels or so I understand.
Perhaps because of their extensive expansion someone though they should be regarded as frangible? They are however definitely section 5 not section 1.
It's a tricky one the HO Guidance states -

4.3 The words ‘designed or adapted’ are important. Any bullet will deform on impact with a
sufficiently hard surface, but only bullets, and ammunition containing bullets, which were
designed or have been adapted to do so in a controlled manner are actually controlled by
the legislation (see Chapter 3). If in doubt as to the design intention of a bullet, reference
to the maker’s design specification should be made. Frangible bullets do not fall under
section 5(1A)(f) of the 1968 Act.


The question do VG bullets expand in a controlled manner? IMO I would say no, especially from the description from Barnes themselves - http://www.barnesbullets.com/bullets/varmint-grenade/

The bullet remains intact at ultra-high velocities in fast twist barrels, while its highly frangible core fragments violently on impact. Produces instant fragmentation, virtually vaporizing ground squirrels and prairie dogs, even at long range. Varmint Grenades instantly expend their energy, seldom exiting large predators like bobcats and coyotes, leaving valuable pelts virtually undamaged.

The trick would be finding a RFD willing to agree to sell them as section 1...
“The standard you walk past is the standard you accept.”

Lieutenant General David Morrison

I plink, therefore I shoot.
User avatar
Sandgroper
Full-Bore UK Supporter
Posts: 4735
Joined: Sat Nov 06, 2010 3:45 pm
Location: Stanley, Falkland Islands
Contact:

Re: Varmint Grenade

#10 Post by Sandgroper »

Ovenpaa wrote:Just checked, Millers shows the stability factor (SG) as around 0.645 so they are going to be unstable with a 1:14 even at 3,925fps. one minor plus side is they are flat based and Millers does not really take this into account however I doubt the flat base will pull the SG to anything reasonable. Thanks for pointing that out DL.
Barnes recommends 1:10 for the 50gn VG. The 36gn bullets according to their load data can be pushed from between 3900-4400fps in a 1:14 22-250!
“The standard you walk past is the standard you accept.”

Lieutenant General David Morrison

I plink, therefore I shoot.
Post Reply

Who is online

Users browsing this forum: Majestic-12 [Bot] and 5 guests