winchester sx3 problem

[nearly there]

Hi guys looking for some advice.I have a fac sx3 and having a wee bit of a feed problem.sometimes when loading the magazine it's as if it's full IE won't let me insert any cartridges but if I try at a angle it works.is there a known issue with the sx3.thanks

[Activ8]

What a strange fault... I know they recalled the SXP for feed issues or something along those lines, but not heard of any SX3 problems.
Is this a new shotgun with a problem or an older one with a new issue? Just thinking about warranty etc.

[nearly there]

Older one with a new issue.I've been told it was a known sx3 issue.supposedly the feed ramp and magazine are not flush

[Activ8]

Older one with a new issue.I've been told it was a known sx3 issue.supposedly the feed ramp and magazine are not flush

That would explain the need to load at a particular orientation

[nearly there]

Just wondering if it's fixable myself or a gunsmith job.

[Blackstuff]

Have a goosey on the FourIslands forum and/or UKPSA (if you're a member), I'm sure it will have been covered if its a known issue

[nearly there]

Can anyone recommend a gun Smith who slicks up shotguns.thanks

[Blackstuff]

Andy Haines at Masterclass custom or the good folks at Shield shooting centre. I haven't found anyone up Norf that specialises unfortunately.

[Activ8]

Andy Haines at Masterclass custom or the good folks at Shield shooting centre. I haven't found anyone up Norf that specialises unfortunately.

Depends where up north. Cheshire Gun Room have 3 gunsmiths on site & one specialises in all things shotgun.

[Blackstuff]

I meant ACTUAL North

Thanks for the tip on Cheshire though, that's a bit closer and not too much of a hike if I was going to Rossendale or Diggle