Hornady 285grain .338LM with N560/70

This section is for reloading and ammunition only, all loads found in here are used strictly at your own risk, if in doubt ask again.
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should treated as suspect and not used.

Moderator: dromia

Forum rules
All handloading data posted on Full-Bore UK from 23/2/2021 must reference the published pressure tested data it was sourced from, posts without such verification will be removed.
Any existing data without such a reference should be treated as suspect and not used.

Use reloading information posted here at your own risk. This forum (http://www.full-bore.co.uk) is not responsible for any property damage or personal injury as a consequence of using reloading data posted here, the information is individual members findings and observations only. Always verify the load data and be absolutely sure your firearm can handle the load, especially older ones. If in doubt start low and work your way up.
Post Reply
Message
Author
ColinR

Hornady 285grain .338LM with N560/70

#1 Post by ColinR »

Does anyone have any load data for the Hornady 285 grain .338 BTHP for .338LM with N560/70. So far I have tried them with Retumbo without much success although perhaps I should have persevered. Given the spec of this bullet they should shoot well in an AI AWM although the COL is such they will not fit the mag. Any other suggested loads for this bullet using Vit. powders would be appreciated.

Edit: Just saw this bullet is now on the Vit Reloading data, but any practical experience with this bullet/load will be of interest
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest